This single sided circuit board is designed for up to 8 Bedini SG circuits. The kit comes with matched transistors, neon bulbs, diodes, resistors and connection terminals and includes detailed assembly instructions. This board was designed by TeslagenX, Inc. based on the board used by John Bedini at the 2013 Bedini-Lindeman conference and shown in The Bedini-SG Machine.
The board is provisioned for heat sinking if running in repulsion mode; it is also useful for positioning the transistors prior to soldering.
The PCB includes the following:
- 1 x Circuit Board (PCB)
- Complete circuit schematic
The PCB & Heatsinks includes the following:
- 1 x Circuit Board (PCB)
- 2 x aluminum heat sinks with screws
- Complete circuit schematic
The kit includes the following:
- 1 x Circuit Board (PCB)
- 8 x matched MJL21194 transistors
- 8 x transistor thermal pads
- 2 x aluminum heat sinks with screws
- 16 x 1N4007
- 8 x 470 ohm 1W resistors
- 1 x 12 ohm 10W resistor
- 8 x Neon bulbs
- 8 x 4.7K ohm 1/4W resistors
- Screw terminal blocks to connect coil wires and batteries
- Extensive pictorial assembly instructions with parts recommendations and tuning instructions
- Complete circuit schematic